Norm limitation EN 61537-1 ed.2007
Zamet Spa informs you that, for compliance with the standard EN 61537-1 ed.2007, the following instructions must be taken into account during the installation of the straight cable tray section and accessories.
The following versions of the ZS Series have been certified for the corresponding corrosion resistance according to paragraph 6.5.2:
- Sendzimir galvanized steel (code 01): Class 3
- Hot dip galvanized steel (code 03): Class 6
- Stainless steel AISI 304 (code 40): Class 9A
The SWL of the straight section for each width, depending on the span and of the supporting devices, is shown in the corresponding tables.
In correspondence with each component of the system (except the T0/S3 212 joint) a certified supporting device must be fitted.
Screws, nuts and bolts used for the assembly of the components housing the cables must be positioned in such a way that the round head is directed towards the inside of the cable tray or component.
This is necessary to ensure full compliance with the requirements of paragraph 9.3.
The tightening torque of the M6 must be 2,5Nm and M8 screws, nuts and bolts must be 6Nm.
Classification according to the surface of open base as per the requirements of the paragraph 6.8, i.e.:
- Classification “X” for cable trays and components with a width of 100 mm
- Classification “Z” for cable trays and components with a width of 200 to 600 mm
The ZS series is tested by IMQ for 300, 600, 900 radii and the logo applied certifies the compliance of the system with standard EN 61537-1: 2007
Certification GOST R TRCU (EAC)
Our product series are NOT INCLUDED
